Gen 2 parts for sale. See list and let me know if any questions. Most are located in Lancaster PA, but I'm making a trip to the Cleveland OH area in a week or two and could drop something off along the way if that works good for anyone.
Armrest, Black
Bed Extender
Bed Cover with key, one...
$125 - I have a complete set of 4 rotors, slotted/drilled Powerstop Evolution Coated. Purchased for a 2010 Adrenalin. New except for less then 100 miles. Nothing wrong with them but decided that didn't like the light clicking noise made by slotted rotors. Located in Lancaster PA but I'll be...
I have an extra Gen 2 bed extender. But some low life trash piece of scum absconded with my Gen 1 bed extender right out of my yard during cover of darkness while I didn't have a bead on him.
If anyone is interested in an even swap I would be happy to do so. The Gen 1 (2003) bed extender...
Too bad about your truck.
The plugs break off sometimes when removing . I bought an 2007 4.6 with 3 or 4 broken exhaust manifold studs and I let my mech pull the engine to fix. He replaced all plugs while we had it out just to avoid future problems.
Also, I think all the 07's have a solid...
Hi All Again - I joined here ages ago but haven't been very active. But I'm back!
I'm looking for my 3rd ST. I want a 2008+ either a Limited 4.6 or an Adrenalin 4.6, preferably under 90k miles. I'm willing to go anywhere in North America.
I just started looking. I did see...
Wow, that was pretty slick. Although I hate messing with air bags.
Does anyone have something equally slick for finding the Gen 2 door code?
Is behind the fuse box the only place to find it? I can't squeeze in close enough to see it or get a picture.
I'm doing the same thing in a 2007 Gen 2. Just bought a 2010 Adrenalin interior. Plugs under the buckets are different. If you didn't use a wiring schematic, did you just match up same wire color for same wire color?
I misread, I just noticed you changed manual to 10 way pwr seats. I...
Had the same thing. Even rusted thru in the front where salt and stones hit them. My clips were part of the rubber tread. If yours the same, you can go from below and squeeze them together and push them thru. I did break the first one when trying to pry it up, but after going at it from the...
So I got the flash blinking left signal on dash, no power at left rear tail light.
I found a project for the fix but the pdf pulls up as an error. Did it not transfer to the new site?
http://www.sporttrac.org/mysporttrac-archive/projects/steering_column_wiring_repair_gen1.pdf
By the way...
We tried mounting Gen2 seat and tracks to a gen1 floor mounting hardware - ended up way too high and need to start over. I just need the bottom of the seat, prefer that it's electric but not critical. No need for the foam or fabric/leather.