Todd Z's latest activity

the connector is the EGR feed back sensor..... or DPFE... see the other thread posted...

No mount. it floats there. Get motorcraft one only. Take the rubber off the metal pipes and squeeze the rubber crushing the plastic and...

Ugh this pisses me off because i've seen that dam connector.... Just cant remember. The sensor looks like a crank sensor to me. Sorry...

Magnaflow makes a large SUV muffler, Cut out all the crap under and replace.... Best will get.

Welcome, ITs slow here. but good info.

DOT made them illegal.... no one can legally sell.

Sadly this can happen, If you don't prime them or the chains are slacked or the guides broken and the new tensioner pushes better on it...

No ST v6 sounds good.

Interior Switch left on ?? By your knee.

This sounds like a fuel pump, maf, wiring or other issue, not a key issue.

The rust gets hidden Under the panels, Inside the fenders and what not. Outside photos mean nothing. The Gen 2 almost the same.

Open the driver door, Pull the rubber trim back, Yank open the side panel on the dash. If there is a Module planted in there it has...

These things are not fool proof....

Just don't yank too hard the resistor goes flying, Hopefully it stays in there, Simple solder job.

Basic Maintenance helps too, Filters, Fluids, plugs wires. Everyone says they are all new or ok, Yep, Not the case.