Search results

Just an update and a thank you to those that were helping with it. About 2 to 3 months ago I did complete the repainting of the Nerf bars. I did use bedliner spray paint took everybody's advice also put painters tape over the holes after I got the pads off kept the same pads so now the Nerf...

I am looking to upgrade the cigar lighter a power port. My 2002 sport Trac has the standard cigar lighter on the left-hand side of the radio. When using it as a PowerPort the plugs don't always connect properly leaving the plug on or off or rotating while driving. I have replaced the cigar...

I have a 2002 ST. The floor covering/rubber floor has developed a hole where The heel to my shoe sits. I do not want to have to replace the entire floor since it is not cost effective for me to do at this time. The whole is approximately 2" x 1.5". I was thinking of getting some carpeting...

I'm now thinking what paint should I use on the nerf bars. I am going to go from factory light grey to black. And also I'm thinking of painting the step pads too. Any suggestions? I was thinking of using bedtimes paint on the step pads. And don't kone what paint to use on the actual bars...

Thanks for the info. I now am armed to attack the project.

I have a 2002 ST. The Nerf bars are pretty scratched up on the top side. I was thinking of spray painting them black with the bedliner spray paint. I see how to get the Nerf bars themselves off. But how do you get the step pads off. The step pads are gray and so are the nerf bars. So I was...

I bought a new blower motor resistors. And the electrical connection that connects to it looked good too so I didn't replace that. I have a feeling it's just the switch.

Update on mine I change the blower motor resistor and now I'm back to speeds 12 and four but speed three does not work it is the same as speed 2 Does anybody think that might just be the switch in the AC control panel

Update on the situation I replaced the oil pressure sensor and it seems to have fixed the problem but what a pain in the but it was getting the sensor connector disconnected

I keep good tabs on the oil and it's never low. I'm betting it's the pressure sending unit. If anybody has any step-by-step son best way to access it i.e. panels to be removed with pictures would be great. Thanks for all the help

Thanks. I'll change the sending unit. Are there any how to's out there if so how about a link or address

Thanks. I found the how to's on YouTube. Seems easy enough (famous last words)

I've had my 2002 ST for almost 8 years. The climate control blower has always been flaky to say the least. It is always blown well in first second and fourth speed. Third speed is always been equal to the second. Just recently now I have speeds one and four. Could this be the climate control...

This is my first post. I have an interesting situation happening with my 2002 ST. After driving a while with the air conditioning on I will come to a stop. Then the oil pressure gauge will just start flicking back-and-forth violently. If I turn the air conditioning blower switch down lower it...