Search results

Ford SportTrac Forum

Help Support Ford SportTrac Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. E

    Replacing Rocker Panels 2010 Adrenalin - some questions

    I had a local body shop fabricate parts
  2. E

    Replacement PCM recommendation

    Before you buy a new ECM try this. I did not and it cost me $926. Mine was not bad but this fixed it. That reset does not always drain all the capacitors in the ECM. This can make act like a bad ECM. Do this but will reset The ECM to factory. You will lose all your settings and have to drive...
  3. E

    Replacement PCM recommendation

    I purchased a new one from Flagship One 516-766-2223 Mine had a problem with the water temp It was programed to your vin The part number was superceided twice It runs great and gas mileage is much better without losing any power You may have to have your keys reprogramed Expensive though $929
  4. E

    Vehicle Wanted WTB 2008-2010 4.6 LTD or Adrenalin

    Hi Robert, I have a 2010 ST Adrenaline with 87, miles. Red in color. With black leather. Please let me know if you are interested.
  5. E

    High Temp Indication

    Thanks. When the temp light comes on I will turn off engine and restart 30 sec to 1 minute later and temp gauge is back to Norman. With a temp gun every spot on the engine is around 200. Have also replaced temp switch (what a pain). also reads computer reads like the gauge. will start looking...
  6. E

    High Temp Indication

    I'm not a dummy Todd as YOU insinuate. We are on here to help each other or so I THOUGH!!! Replaced thermostat, flushed, coolant is full in radiator when cold. I have also cleaned ECM terminals and battery terminals. Will check harness where others have suggested. Thanks everyone
  7. E

    High Temp Indication

    AC cuts out then the water temp high light comes on then goes into limp in mode. Shut engine off and restart after 30 sec and everything is normal. ????
  8. E

    High Temp Indication

    My 2010 STA with 4.6 dash light comes on. engine heads are not hot, checked with temp gun at 200 F. Dealer replaced temp sensor and still indicates hot. Scanner shows 260 F but again not to touch or with temp gun. Bad wire to ECM or bad ECM? Dealer can't figure it out. Only has 86000 on it. Help
  9. E

    What is your tie down set up?

    I made mine. bent 1/4 rod with hook
  10. E

    Head gasket

    My son has a 2002 ford explorer with the 4.0 V6. Its chains started rattleing about 100k. It now has 357k without anything done to it. Trans if a different story.
  11. E

    Well ...a little over 307,000 miles on my 4.0L SOHC and I've gotten the infamous start-up chain rattle.

    My son has a 2002 Explorer with the 4.0. The chains started rattling about 100k. He never replaced them and kept driving. It now has 359k and still running great. No engine other routine oil, coolant, and transmision fluid changes. couldnt ask for better
  12. E

    Cold start Exhaust leak

    Did Ford pay for this?
  13. E

    Exhaust Manifold Leak - Rt side

    Same as my 2010 4.6. A common trouble with the 4.6. I was able to replace the right manifold and studs without removing the engine. It was hard having to drill out several studs but it is possible. It took almost 7 hours. I unbolted the left motor mount which helped
  14. E

    Exhaust Manifold Leak - Rt side

    Same as my 2010 4.6. A common trouble with the 4.6. I was able to replace the right manifold and studs without removing the engine. It was hard having to drill out several studs but it is possible. It took almost 7 hours. I unbolted the left motor mount which helped.
Top