Reply to thread

Help Support Ford SportTrac Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="Heather Rueckert" data-source="post: 544549" data-attributes="member: 60730">I got my bed divider re-installed (without notching it) and the EZ lift funtioning as well.  I unhooked the rear shocks, flipped the tonneau cover back. Unhooked one side of the tonneau latches at a time, then located the hole behind the EZ Lift mounting plate that my divider rod slides into and measured from the lower mounting plate bolt hole up to the hole I needed. It was exactly 1 1/4" above it, (which happened to be directly in the center of the silver EZ Lift sticker). I drilled a 3/8" hole through the mounting plate, and re-installed the mounting plate. Then did the same thing on the other side of the bed. The holes lined up perfectly and then my bed divider slid in and re-latched with no problem. Then I relatched the tonneau, then hooked the shocks back up. Took about 45 minutes.  Just wanted to let you all know it can be done! <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite2" alt=";)" title="Wink    ;)" loading="lazy" data-shortname=";)" />  Rich- Maybe you could put a little disclaimer on your site that the EZ lift will only work with the bed divider if you drill out the extra 3/8" hole on the mounting plate. Other than this one problem I am very happy with your product! <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite8" alt=":D" title="Big Grin    :D" loading="lazy" data-shortname=":D" />   -Heather</blockquote>

Verification