Scott Heckler
Well-Known Member
SWEET! It took me a total of three hours to get both on. Nice sound and great power!
Thanks again Team Zabteck
Thanks again Team Zabteck
High Flow Cat and Y Pipe INSTALLED!
- Thread starter Scott Heckler
- Start date
Help Support Ford SportTrac Forum:
- Joined
- Sep 21, 2003
- Messages
- 22,458
- Reaction score
- 796
- Location
- Long Island, NY
- What engine do you have?
- V8 engine
- What year is your Sport Trac?
- 2010
- What Generation is your Sport Trac?
- 2n Gen Owner
COOL DEAL !!!!!!
What did you wind up doing with the 02 ???
Todd Z
What did you wind up doing with the 02 ???
Todd Z
Daniel B
Member
pics and a video is a must!
Or else....umm..you'll get banned..yeah thats it you'll get banned
LOL
Or else....umm..you'll get banned..yeah thats it you'll get banned
LOL
George C
Well-Known Member
Scott,
I'm glad everything worked out for you. Drive it a little and the sound will get even better!
George
I'm glad everything worked out for you. Drive it a little and the sound will get even better!
George
Scott Heckler
Well-Known Member
I followed Lee's suggestion and took notice of how many turns it was when I finally broke the Y pipe's O2's free. Once you get them turning you can almost take them out by hand, even on a 2001 . . . .. The passenger side O2 can be gotten to via the wheel well. The one on the other side is easier if you drop the y pipe just a little to get a wrench on it. The O2 above the cat you can reach the plug and disconnect it, remove the cat, and deal with it off the trac.
Installing the O2's I just turned the O2 about four turns to "wind" up the wires so when I screw it in the wires will un twist.
Sorry I did not get any pictures, my hands were sooooo dirty.
I will say a tip to installing both is put the y pipe in place and only put the nuts back on to hold it, don't tighten it yet. Then install the high flow cat and make the connection between the two first, then tighten the y-pipe's nuts.
Installing the O2's I just turned the O2 about four turns to "wind" up the wires so when I screw it in the wires will un twist.
Sorry I did not get any pictures, my hands were sooooo dirty.
I will say a tip to installing both is put the y pipe in place and only put the nuts back on to hold it, don't tighten it yet. Then install the high flow cat and make the connection between the two first, then tighten the y-pipe's nuts.
