Looking for wheel spacer info

[Bill Geiger 2]

Can any of you give me part numbers and manufacturer names for wheel spacers that work with the trac? My brother-in-law works for Jack Williams Tire and auto, he has been "trying" to get wheel spacers that work for the trac, but says that everytime he orders some and puts them on the trac shakes uncontrolably. He first tried the spacers that just sit behind the wheel and I told him that they would not work. He then ordered a set that bolt on, and just told me that they shake too.



Any Ideas?



Thanks for the help.



Bill

 

[Michael Cacioppo]

What thickness are you looking for. I have 1.25 inch billet aluminum spacers that I took off my Trac. Never had a problem with them. You should use concentric lug nuts to attach the spacer to the drum/rotor to guarantee alignment. Drop me a line if you are interested.

 

[WT Ballard]

do you want to sell them?

 

[Tom Higbee]

Whatever you get, but SURE they are CONCENTRIC!!!

 

[Matt Lane]

Mike, I might also be interested if you're looking to sell them...

thanks

 

[Michael Cacioppo]

I have one pair (new), 1 pair exceptionally clean with 1/2 X 20 studs both 5 on 4.5". I have another pair exceptionally clean with 12 mm X 1.5 studs. Again, 5X4.5 spacing. All are 1.25 inches thick and are of billet aluminum. Give me an E-Mail @ [email protected] if you are interested in buying any. Remember you still need to get hub-centric lugs to attach spacer to vehicle. Gorilla brand sells these. I will put these up on Swap and Sell. wtbtl, you have first pick if interested.

 

[Todd Z]

I can vouch for mike C, He is a good guy, you can be sure the deal will go smoothly if you get them from him...

I did not know any one had them and I just got a set off Ebay...:-(



I am personally NOT a fan of wheel spacers, But i am going to do some testing..

So far i am impressed... I may put them on....

Todd Z

 

[JOHN TLOCKOWSKI]

Bill.

Check out my wheel spacer project.