I purchased a used overhead console for my 04 ST off of ebay that included the bracket, temp sensor and the complete wiring harness with a plug on each end. I have installed the console but have not wired it up yet. I have read the helpful instructions for wiring (Installing Overhead Console) in the Projects Page on this site as well as a set of similar instructions on another site. Both of these instructions are for only "partial" harnesses. Can I just plug one end to the console and the other end up somewhere under the dash? or will I need to follow the instuctions per wire? Thanks!
Overhead Console Wiring
- Thread starter Paul P 3
- Start date
Help Support Ford SportTrac Forum:
- Joined
- Sep 21, 2003
- Messages
- 22,485
- Reaction score
- 812
- Location
- Long Island, NY
- What engine do you have?
- V8 engine
- What year is your Sport Trac?
- 2010
- What Generation is your Sport Trac?
- 2n Gen Owner
If you got the complete setup, the other end is some where in one of the kick panels or under the dash.. The sensor wire should be under the hood...
Most members have simply ran new wires..
Todd Z
Most members have simply ran new wires..
Todd Z
Thanks Todd. The complete harness is not long enough to get to the kick panel. It ends up right around the fuse box down the A-Frame. My "untrained" eye does not see any receptor plug around where it ends up. Did not know to keep looking or what.
LB
Active Member
Paul. I rigged mine up. Let me know if you have any questions.
