Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
SportTrac Discussion
Electrical
Power Mirrors kinda not workin
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Ford SportTrac Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="MarkDawn Houlahan" data-source="post: 540087" data-attributes="member: 55949"><p>The switch is retained by two plastic barbs that grab the door panel. You can get the switch out with careful screwdriver pry/extraction, but you'd be safer removing the door panel. Reason being, the wiring connector is too big to allow the switch to come through the panel. I had to pry the switch out a bit and then disconnect the wiring with another push of a screwdriver.</p><p></p><p></p><p></p><p>On installation I plugged the harness in and forced it through the door panel. It was tight, and no marks on the door, but it might be tough for some people.</p><p></p><p></p><p></p><p>I say take the door panel off, it's only a couple of screws and push pins.</p><p></p><p></p><p></p><p>Let me know if you need any help. I'll try to go from memory as its been about three months since I fixed the switch on ours.</p><p></p><p></p><p></p><p>Mark</p></blockquote><p></p>
[QUOTE="MarkDawn Houlahan, post: 540087, member: 55949"] The switch is retained by two plastic barbs that grab the door panel. You can get the switch out with careful screwdriver pry/extraction, but you'd be safer removing the door panel. Reason being, the wiring connector is too big to allow the switch to come through the panel. I had to pry the switch out a bit and then disconnect the wiring with another push of a screwdriver. On installation I plugged the harness in and forced it through the door panel. It was tight, and no marks on the door, but it might be tough for some people. I say take the door panel off, it's only a couple of screws and push pins. Let me know if you need any help. I'll try to go from memory as its been about three months since I fixed the switch on ours. Mark [/QUOTE]
Insert quotes…
Verification
Post reply
SportTrac Discussion
Electrical
Power Mirrors kinda not workin
Top