Matt Dodd
Member
Hi all,
The lock cylinders on the 1st gen covers hang super low into the bed. Especially when I have a full load, I am terrified that I am going to snap one off (at a cost of $60 or so). Anyone fabbed up some metal covers / protection for them? Alternatively, if I can Google Sketchup a design, is there anyone with the requisite tools / skills than can fab them up? I am sure there are some others on here who would appreciate a similar solution.
Thanks!
The lock cylinders on the 1st gen covers hang super low into the bed. Especially when I have a full load, I am terrified that I am going to snap one off (at a cost of $60 or so). Anyone fabbed up some metal covers / protection for them? Alternatively, if I can Google Sketchup a design, is there anyone with the requisite tools / skills than can fab them up? I am sure there are some others on here who would appreciate a similar solution.
Thanks!