Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
SportTrac Discussion
General Sport Trac Discussion
Replacement PCM recommendation
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Ford SportTrac Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Redrooster" data-source="post: 1047485" data-attributes="member: 77808"><p>reset the PCM and drained it. The fuel gauge initially went to E when I turned it on (not below E) but after a minute or two the gauge dropped below E and the check engine light came back on. I force wrote the as built data again but I am wondering if I am doing it wrong , it says executing service procedure but is stuck on 0% and never doesn’t do anything after read block 1 write block 1, but if I hit stop it says service procedure completed successfully.</p></blockquote><p></p>
[QUOTE="Redrooster, post: 1047485, member: 77808"] reset the PCM and drained it. The fuel gauge initially went to E when I turned it on (not below E) but after a minute or two the gauge dropped below E and the check engine light came back on. I force wrote the as built data again but I am wondering if I am doing it wrong , it says executing service procedure but is stuck on 0% and never doesn’t do anything after read block 1 write block 1, but if I hit stop it says service procedure completed successfully. [/QUOTE]
Insert quotes…
Verification
Post reply
SportTrac Discussion
General Sport Trac Discussion
Replacement PCM recommendation
Top