ST wont start after changing fuel filter

Ford SportTrac Forum

Help Support Ford SportTrac Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Peg Leg

Member
Joined
Jan 20, 2006
Messages
29
Reaction score
0
Location
Huntsville, AL
My 05 ST wil not start after changing fuel filter, has excess of 60psi of pressure measured fom the engine side of new fuel filter(reason I changed filter was to measure fuel pressure to make sure rough idle wasn't fuel pump or filter causing a P0190 code) The fuse is good and replaced, filter arrow is pointing toward engine. I followed the Project directions to the tee after getting the right fuse layout from fellow member. What could I have screwed up, I cranked it many time, so I'm sure it's primed. I even took the fuel line off again and measured pressure and still got above 60 psi when cranking.



Any ideas



PL
 
First thing I checked I don't have one, just the harnass with a disconnect, I unpluged and replugeg, I can here the pump start, and I check the pressure and flow from the engine side of the new filter, > 60psi when cranking, and gas flow into the pressure test clear line.



Pl
 

Latest posts

Top