Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
SportTrac Discussion
Electrical
Voltage Stabilizer: Sham or Not?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Ford SportTrac Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Travis Munday" data-source="post: 563084" data-attributes="member: 52914"><p>Thanks MikeC, for you understand electrical components when in use on an auto.</p><p></p><p></p><p></p><p>The best way to kill an electrical circuit is to cause it over heat. One of the best ways to overheat a circuit is through poor wire, either too small or poor conductor, kinks, cutc, knicks, and poor connections. Improve any of these, and you'll increase the reliability of said circuit, and make the circuit preform better because the electricity isn't working as hard. Same reason why people add intakes and exhuasts....it puts less strain on the engine making it more efficient and work better, ie, more performance.</p><p></p><p></p><p></p><p>LB, while the "spec" electrical system would work, there's no use in causing premature component failure, or an unsafe situation. Good vehicle grounds and hots, depending on just how much you want to add, wouldn't be a bad idea to upgrade.</p></blockquote><p></p>
[QUOTE="Travis Munday, post: 563084, member: 52914"] Thanks MikeC, for you understand electrical components when in use on an auto. The best way to kill an electrical circuit is to cause it over heat. One of the best ways to overheat a circuit is through poor wire, either too small or poor conductor, kinks, cutc, knicks, and poor connections. Improve any of these, and you'll increase the reliability of said circuit, and make the circuit preform better because the electricity isn't working as hard. Same reason why people add intakes and exhuasts....it puts less strain on the engine making it more efficient and work better, ie, more performance. LB, while the "spec" electrical system would work, there's no use in causing premature component failure, or an unsafe situation. Good vehicle grounds and hots, depending on just how much you want to add, wouldn't be a bad idea to upgrade. [/QUOTE]
Insert quotes…
Verification
Post reply
SportTrac Discussion
Electrical
Voltage Stabilizer: Sham or Not?
Top