Recent content by Delphi Guru

The first time this happened, I stepped on the brake pedal and then it turned and cranked up. The second time stepping on brake pedal had no effect, but shifting to neutral and back to park did the trick. The third time, pressing brake pedal and shifting gears did not work, so I pulled key out...

Owned for 11 yrs. 2007 4.0L has 145k miles, replaced thermostat housing, 2 batteries, harmonic balancer, radiator.

Yes, it worked...mostly... It was still slipping just a bit, so I created a wooden wedge and put between the belt and fan pulley, so it would pull into that gap and get tighter as I tapped the 36mm wrench. So, with your solution and my wooden wedge, it did the trick... Thank you very much! I...

Thank you for this advice. I will try the belt tensioner solution and post back...

Just wanted to let all know that IT WAS a wiring issue. The harness that runs under the battery and under/to the fuse box had 2 broken wires and over a dozen wires with insulation damage. After going through every wire in this harness and soldering/taping, ALL IS GOOD! Thank you everyone for...

Hi All, Great site. Great info here. I'm working on replacing my radiator. I purchased the 36mm thin wrench needed to remove the fan. My problem is, I can not stop the pulley from spinning when trying to break the nut loose. I saw a video where someone used a HUGE pipe wrench to hold the...

Thank you for your advice and the video links. I will watch them and see if I can locate and fix a wiring issue.

3 grand....Ouch! I think if I put 3 grand into my truck, I could probably sell it for 3 grand...lol. I agree with potential wiring issue. I towed it to the Ford place a month ago. They reprogrammed the PCM (because the previous mechanic had swapped it out only to find it made no difference, then...

I swapped all of the relays and it did not make a difference. Thanks for the advice. Also, just replaced the fuel filter, air filter and pcv....still get the same 6 codes....not right away though. I cleared the codes, then cranked it up and let it idle for about 10 minutes, no error lights...

I will do that. Thanks again...

I did check all the fuses, but not the relays. Thanks for that suggestion. Now I have to research how to test a relay...

Hi All, Great site...I'm glad I found it. I have read many posts before posting..... I am getting the following codes from my ODB-II P0135 O2 Sensor Heater Circuit Bank 1 Sensor 1 P0141 O2 Sensor Heater Circuit Bank 1 Sensor 2 P0155...