Search results

I got the pcv valve already and the hoses are fine, the piece im missing and nobody seems to have, because i've check with several parts places is a small plastic y connector that goes on top of the pcv valve that the vacuum hose attaches to. If anybody knows were I can find it without having to...

I have a 2001 job 1 4X4 with 120,000 miles on it was going to change the pcv valve my trac has the misfortune of needing a EV-147 pcv which was somewhat hard to find, however the dealership did have one but the top part for the vacum lines was not the same. they recommended to use the old one...

I will be replacing my rear axle seal soon due to it leaking and was thinking that I might as well replace the wheel bearings while it was torn apart, any comments if this is a waste of time and money. My st is a 2001 job1 4x4 with 93000 miles. I have not had any problems with the bearings or...

the yoke is the short drive shaft that goes into the diff, they cost about 38.00 to get a new one. If you run your finger down the shaft it should be smooth if you feel a lip then there is vibration from the diff that is causing wear from beating the shaft against the seal. I should say the...

Have them look at your yoke to see if it has a wear mark from the seal if it does then you can plan on doing a seal replacement every 30,000 miles like i've had to. Its caused by vibrations that wear out the seal. only fix is to have the whole diff rebuilt. or you can just do the replacemnt of...