Tim Turner
Well-Known Member
This is a project to install a billet 3rd brake light cover. I purchased mine from autoaccessory4u.com off of Ebay.
Start by removing the two screws that hold the 3rd brake light lense on but do not pull the brake light lense completely off.
Place the billet cover over the lense and hand tighten the screws into the holes, making sure that the cover is level. I used longer screws that were provided with the product, because it made the install easier, but was not necessary.<P>Finally tighten the screws using a screwdriver to secure the billet cover. Make sure not to overtighten as it may crack the clear lense. Silicon may be added around the screw holes to prevent water.
Before
After
Start by removing the two screws that hold the 3rd brake light lense on but do not pull the brake light lense completely off.
Place the billet cover over the lense and hand tighten the screws into the holes, making sure that the cover is level. I used longer screws that were provided with the product, because it made the install easier, but was not necessary.<P>Finally tighten the screws using a screwdriver to secure the billet cover. Make sure not to overtighten as it may crack the clear lense. Silicon may be added around the screw holes to prevent water.
Before
After
Last edited by a moderator: