Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
SportTrac Discussion
General Sport Trac Discussion
Back Power Window
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Ford SportTrac Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Jim Sacco" data-source="post: 1014285" data-attributes="member: 61894"><p>Ok. I tore out the regulator, and ordered a new one (as the motor sounded like it was trying to respond to the initialization). I installed the new regulator, and attempted to initialize it. I went through the procedure, and the window went up, but then no more response. Also, when I started the procedure, it did not move up & down (to show that it entered the initialization mode) as it states on the procedure. It just goes up, and stops. Does this mean I need a new motor unit? One of the sets of initialization instructions states that if you try to initialize it twice, and it still doesn't work, to replace the motor unit.</p><p></p><p></p><p></p><p>BTW, until I tore out the regulator, I didn't know why it wasn't working. After looking at the back, I saw where the wings on the plastic pulley had broken, and allowed the cable to slip out, and jam between the pulley and the metal track.</p></blockquote><p></p>
[QUOTE="Jim Sacco, post: 1014285, member: 61894"] Ok. I tore out the regulator, and ordered a new one (as the motor sounded like it was trying to respond to the initialization). I installed the new regulator, and attempted to initialize it. I went through the procedure, and the window went up, but then no more response. Also, when I started the procedure, it did not move up & down (to show that it entered the initialization mode) as it states on the procedure. It just goes up, and stops. Does this mean I need a new motor unit? One of the sets of initialization instructions states that if you try to initialize it twice, and it still doesn't work, to replace the motor unit. BTW, until I tore out the regulator, I didn't know why it wasn't working. After looking at the back, I saw where the wings on the plastic pulley had broken, and allowed the cable to slip out, and jam between the pulley and the metal track. [/QUOTE]
Insert quotes…
Verification
Post reply
SportTrac Discussion
General Sport Trac Discussion
Back Power Window
Top