Bolts for Engine Stand for V6 DOHC

[Chris Pinzone]

Hi,



I just swapped out my V6 DOHC that had developed a nasty, death-indicating lower end tap with a low mileage used engine. Since it didn't seize, I'm planning on "rebuilding" the old engine as a way to teach my son about engines. I have lots of help from a friend who's a Ford mechanic so the rebuild should be ok, but I want to mount the engine on a stand that I bought. Does anyone know what size bolts I will need to connect the engine to the stand mounts?



Thanks,



Chris

 

[Richard Turnbull]

I would not be surprised if they are metric, but I don't know, sorry.

 

[Fudged Undies]

M10 thread and depending on the holes used on the block, 40 - 75 mm in length. This is for the 4.0 in the ST correct? You list a DOHC above and the trac is an SOHC.