light bar

[bob mcarthur]

ok i just recieved my flex light bar(pacer) it cals for attaching red wire to a constant power source and the white wire for back up light. what would be the best location for these too splices too be made. pacer outback f 5 model 20-822.



thanks in advanced for your help



bob



oh i forgot its a 08 sport trac

 

[Rob Allen]

I'd think the trailer harness since it's right there...

 

[bob mcarthur]

yes that part is ok but it also has a red wire and a white red must be connected too a continous hot lead. just wonder where though or can i splice in to brake light in housing.

thanks in advance

 

[Rob Allen]

There should be a hot back there. A charge line for your trailer. Do you have the 7pin plug? Should be able to open up a harness going to the brake light if you need to. But all wires should be at the plug

 

[bob mcarthur]

no only have 4 pin plug which match's w/ light set but says need a constant hot (red wire)

and a extra white for back up. but w/ just plug in light comes on w/ head lights. thought this would be easier but that ok live and learn

 

[TRACket Paul]

Just curious, was the powerpoint outlet in Generation 1 bed not carried over to the Gen 2 beds?



[Broken External Image]:

 

[Aaron Yarbough]

Just curious, was the powerpoint outlet in Generation 1 bed not carried over to the Gen 2 beds?

Yes, it's included in the Generation 2 bed...

 

[TRACket Paul]

Thanks Lil Red.

There's the 12V line needed for the lights.

Is it located in the same place on the bed wall?



Then just crawl under under the and look up:

[Broken External Image]:

 

[Aaron Yarbough]

On the Generation 2 it's located at the rear corner on the passenger side of the bed.

 

[bob mcarthur]

awsome thanks Lil red



bob