New Member message

[Carlos Vidal]

Good afternoon as a new member. In the past I've been a beneficiary of the experiences & knowledge of contributing members. Now I can also contribute.

 

[Carlos Vidal]

I share the location of the fuel pressure regulator/damper on a 2001 Ford Explorer Sport Trac for the benefit of others who have spent hours looking for it. It is located at the end of the fuel rail on the driver's side, very close to the firewall.

Yes ... you must remove the plenum to get to it. We first tried removing the ignition coil, but could not get to it.

 

[dvdswan]

Welcome to the site.

 

["Risky Bizness"]

WELCOME !!!

 

[Todd Z]

I share the location of the fuel pressure regulator/damper on a 2001 Ford Explorer Sport Trac for the benefit of others who have spent hours looking for it. It is located at the end of the fuel rail on the driver's side, very close to the firewall.

Yes ... you must remove the plenum to get to it. We first tried removing the ignition coil, but could not get to it.

2001 had 2 engines, would help if you state what motor this was.

 

[ArtCall]

2001 had 2 engines, would help if you state what motor this was.

Is one motor better or more HP than other? I bought an identical 01 ST from estate sale, it
recently had most all front end and rear components replaced. Got it home noticed small differences at motor. Where or what to look for to identify which type? Thanks.

 

[swshawaii]

https://sporttrac.org/threads/difference-between-job-1-and-job-2-for-2001.63791/

 

[Carlos Vidal]

2001 had 2 engines, would help if you state what motor this was.

Mine is a 4.0L V6.

 

[R. Chapman]

Good afternoon as a new member. In the past I've been a beneficiary of the experiences & knowledge of contributing members. Now I can also contribute.

Hi! I'm also new. I also have a 01 Sports Trac that I'm trying to restore. I can him Toothless. I'm trying to figure out the tools needed for removing the door panels. I need to replace 2 interior and 2 exterior handles. Then reprogram the door locks. If you can help, I would appreciate it greatly!
Thanks
Rebecca

 

[Carlos Vidal]

 

[Carlos Vidal]

No special tools are required, screwdrivers are sufficient. If you want to upgrade a bit, consider a kit like the one in the attached photo. Recommend having extra door panel clips, they may come in handy.

Enjoy!

 

[Sarah93003]

Harbor Freight also has the anti-mar tools pictured above.