Steve Krusich
Well-Known Member
My XCal2 instructions recommend removing the fuel pump and fan fuses on "some" vehicles. Does this apply to the SportTrac?
XCal2 install question
- Thread starter Steve Krusich
- Start date
Help Support Ford SportTrac Forum:
Wayne Fajkus
Active Member
the worst case is the program won't load and you go back and remove the fuse. I've never done it on my 4.0 Ranger and had no problems.
shawn stonbraker 2
Well-Known Member
Steve, I don't have one, but read many posts on this subject. Nobody has had a problem when they've NOT pulled the fuses on thier ST.
- Joined
- Sep 21, 2003
- Messages
- 22,458
- Reaction score
- 796
- Location
- Long Island, NY
- What engine do you have?
- V8 engine
- What year is your Sport Trac?
- 2010
- What Generation is your Sport Trac?
- 2n Gen Owner
ONLY the 9100 tuner required the fuse to be removed...
The XCAL's do not..
Todd Z
The XCAL's do not..
Todd Z
Trevor Yeomans
Member
todd..... is there anything you DONT know???:huh:
FlipTrac_511
Well-Known Member
Todd, how many fingers am I holding up?
I've used my XCal2 on several occassions without pulling any fuses to no ill effect. I just make sure everything is turned off.
I've used my XCal2 on several occassions without pulling any fuses to no ill effect. I just make sure everything is turned off.
Last edited by a moderator:
Chris P
Active Member
one, the middle one:lol:
