Gen 2 Adrenalin fog lamp replacement

[Richard McAlister]

I need to replace my foglamp bulbs, but cannot figure out how to remove the bulb socket from the fog light assembly. Do they twist out, have snaps, or something else? 2010 STA.

thx

 

[A1cntrler]

What is the bulb number? My Gen2 Trac takes a 9145 bulb in the fogs (Not sure if the STA is the same or not). If it's a 9145, it takes about a 1/4 turn counterclockwise and the pull the bulb out. Install is opposite of removal.

 

[Todd Z]

Gen2 STA is a complete assembly, Take the whole dam lens out of the bumper, Clips, and then remove..



Todd Z

 

[Jim Upton]

The bulb itself has 2 tabs you squeeze in then twist, never had to take the whole assembly out. The bulb is an H16,5202, ps24w depending on brand.

 

[Robert Caffyn]

I just unplugged the bulb and replaced with an LED bulb.

 

[Jim Upton]

Bob C, what did you use for LED bulb #. I would like to go that route myself. Thanks

 

[Robert Caffyn]

I just picked up a 2010 ST Adrenalin. The LED replacement number, I got off of Sylvania's list of bulb numbers for the truck. www.superbrightleds.com, I think its #5208. It has LED's around the four sides, but a single reflector led on the front. They are pretty bright. Plug and play, real simple. Just crawl under air dam and reach up and unplug.

 

[Kris Smith]

Gen2 STA is a complete assembly, Take the whole dam lens out of the bumper, Clips, and then remove..



Todd Z

Mr. Todd,
How do you remove the fog light? I’m under the truck and see the 3 adjusting screws and have removed the black shroud.

 

[Kris Smith]

I just picked up a 2010 ST Adrenalin. The LED replacement number, I got off of Sylvania's list of bulb numbers for the truck. www.superbrightleds.com, I think its #5208. It has LED's around the four sides, but a single reflector led on the front. They are pretty bright. Plug and play, real simple. Just crawl under air dam and reach up and unplug.

Robert,
I just got the same lights. Any suggestions on how to install them? I’m trying to use the oem clips but they don’t seem to want o go back in.