Modification?

[DILLARD000]

With an intent to slightly increase cooling capacity of radiator, replaced
1.5" RadiatorHoses, swapping out StockRubberHoses to new StainlessSteelFlex.
Used kit with 48" length of the SSFlex, $42 at that time from Amazon\Ebay.
Hack sawed off ~32" for UpperHose & ~16" for LowerHose, then easily shaped & routed as needed.
Kit came with RubberSleeves+ChromCovers for the ends; did not like the kits Rubber quality or Chrom look,
so made my own RubberEndSleeves from 1.5" StockRadiatorHose, did not use ChromCovers.
Doubled up the WormClamps for each connection, "Belt & Suspenders".
Sliced RubberHose pieces used to insulate new SSFlex where is was close to plastics or AC tubing.
Again intent was to increase Radiator capacity, which I beieve it did; SSFlex does also look good.

 

[Berf]

I added a Pop N Lock PL 8250 to the tailgate so that the tailgate locks and unlocks with both Key Fob and interior door lock buttons. Also added a soft toneau cover. This allows me to put stuff in the bed, lock the truck, and walk away without worries. The tailgate lock also means I don't have to worry as much about tailgate theft.

 

[dvdswan]

A couple of mods...

F150 turn signal mod, worth it to me as a tall person my knee would hit the turn signal when in the left turn and shut off.

Then the rear tailgate handle with camera mod...

before:

after:

Both are worth it.

For my topper, the PO or installer ran the wires through the holes for the bed extender with wires hanging out. I installed a connector / plug for my topper. It will seal when the topper is off.

 

[DILLARD000]

@dvdswan
Looks like some good practical mods there.

 

[Michael Woodruff]

A couple of mods...

F150 turn signal mod, worth it to me as a tall person my knee would hit the turn signal when in the left turn and shut off.
View attachment 5802

View attachment 5803

Then the rear tailgate handle with camera mod...

before:
View attachment 5804

after:
View attachment 5805

Both are worth it.

For my topper, the PO or installer ran the wires through the holes for the bed extender with wires hanging out. I installed a connector / plug for my topper. It will seal when the topper is off.

View attachment 5806

View attachment 5807

Is the F150 part just higher up? I have the same problem with my stock turn signal stalk. Is it direct replacement?? Got a part # to share if it is?