FlipTrac_511
Well-Known Member
Last month I had camber kits installed for allignment and immediately I noticed squeeking. I sprayed WD40 around the bushings and the camber kits themselves. The squeeking disappeared but now there is a metallic "chatter" or "tapping" when I go over small bumps at speed. The noise is most obvious and consistent when going up driveways. When I took my Trac into the dealership for my tranny service, I had them check out this noise and they pinpointed the kit and my shocks. I really doubt it's my Monroe shocks because the noise occured only after the kit was installed. First thing in the morning I am returning to the shop (again) where I got the allignment from and see what they have to say or do. Just in case this is not resolved, what should I start to look for so that I may do work myself. I also read that using WD40 on the control arm bushings was a no-no as it "turns them into mush".