Search results

Brute forced it off. All good. See ya'll around more.

Been a LONG time since I've been here (last post was in March 2010!! BAD ME!) Anyways, still running my '02, but I have the dreaded PCV vaccum leak and I am hoping someone is on that can give me a hand tonight. What is the secret for removing the end assembly from the PCV valve? The...

Never mind, found it. May post a project with the diagram.

So, rear break lights stopped working. Pulled the front dash apart to look for loose/broken wire at the typical spot: top harness. Sure 'nuff, one wire was loose, that I could see. When I pulled it all apart to fix it, there were 3 more that were loose. Now, I don't know for sure where...

Took her out for a spin and all is well. It's enough for the next week anyway since I will be away from home and won't be using it. Thanks ya'll.

O'Reilly's believes they can turn the non-beat up one just fine. The pads are not getting replaced as they still have over half their life in them.

Thanks guys. My neighbor came over to give me a hand when we discovered that the hub and rotor we expected to be two pieces were one piece... Bearings are in good shape, rear seal is TRASH (had been apparently leaking for some time). Races appear to be good. The rotor will need to be...

Please note that you can't see them, but there are jack stands. The jack is backup.

which nut? The lugs are off, the retainers on the lugs are long gone. The only nut I see is the bearing nut in the center of the assembly. The pad carriage is off. [Broken External Image]:

Going to run down to the store real quick and try to find a cheap propane torch... heat and BFH. Need replacements now that I've beat the driver's side all to hell. Will check back in before starting.

4x2 2002 gen 2

I can't get the damn things loose. Beat on them with a rubber hammer, a framing hammer and a 5lb for 30 mins and nothing. I can't spin the rotor 360 either since appearantly I've knocked the ABS sensor ring out of position... F***!

BTW, the original post about ammo having more restrictions is on in the PRK (People's Republic of Kommiefornia). THIS IS NOT A NATIONWIDE bill.

I believe in stocking up on ammo... 1,000 rounds per common rifle (7.62x39, 7.62x54r, .30-06, etc). 500 rounds per uncommon (.303 Brit, 7.5 Swiss, 8mm, etc). 500 rounds minimum per shotgun. 1,000 rounds per common handgun (.40s&w) and 250 rounds for uncommon handguns (7.62Nagant, 7.62x26, 9x18...

If it goes BANG, I love it. In the market for something new shortly. In AR, you can walk into a store and less than 20 minutes walk out with a handgun, rifle, etc. Supressors are welcome, NFA, ditto and toys with a giggle switch, if you can afford the ammo. Debating my next purchase... a...

Grrrr.... I didn't get a chance to cahnge my driver list this week, though I still managed to get by... But still.. I should be #1!!! 31 points.... gah.

I need a driver's seat bottom cover as well....

Aw crap. Figured it had to have some sort of trick/issue... Would I just be better off going with a new clutch assembly?

Holy crap... need to scale pics...

So yeah... Not the Sport Trac, but it is the ST older sister. So, driving to work this past tuesday, all of a sudden the engine starts making a bad sound. Goes away when the A/C is turned off. Later on, sounds like parts falling out the bottom of the engine. A/C not getting cold...