Mike M 4
Member
Having problems with steering wander, local shop says ball joints. Oh well, I have the parts, and I plan to replace the tie rod ends as well. Got the greasable kind, Moog I think. I have read Caymens post with Pix, and Chads project on half shaft removal. I just have a couple of questions.
How did you get the steering knuckle from the lower ball joint, and did you use a puller?
Is there enough space to pull the steering knuckle from the lower ball joint without disconnecting the upper ball joint?
Looks like you use a jack on the lower A arm to move it in relation to the steering knuckle.
Do you use a puller on the tie rod ends to remove them?
Any other hints or suggestions would be much appreciated. Thank you in advance
How did you get the steering knuckle from the lower ball joint, and did you use a puller?
Is there enough space to pull the steering knuckle from the lower ball joint without disconnecting the upper ball joint?
Looks like you use a jack on the lower A arm to move it in relation to the steering knuckle.
Do you use a puller on the tie rod ends to remove them?
Any other hints or suggestions would be much appreciated. Thank you in advance
Last edited by a moderator: