Sure Guys....
Please don't hold me responsible if anything goes wrong with your project. Just sharing some useful info that I found works for me. Anyone should be able to do this though IMO...
First remove the tail lights and cover the the holes on the back of the tail lights that the bulbs go into with tape. This will keep water and debris out when wetsanding.
Wet sand and use very fine grit (1000+) sand paper to remove any and all "shine" on the exterior of the lens. This insures proper adhesion. Your lens will look like crap when you're done with this step. Don't worry though, the shine will come back when your project is complete.
After all shine has been removed and the entire surface has been evenly scuffed, let dry. When dry, I used a tack cloth to remove all foreign debris from the lens surface. Be sure to keep your greasy fingers away from the lens at this point.
You might want to put on a pair of latex or rubber gloves to keep your hands free of paint as I held mines while painting. Get your nightshades and paint the lens in long even strokes. I held the tail light sideways so that I could paint it in this manner. If I could complain about 1 thing regarding this product, the nozzle sucks. The paint tended to spatter occasionally. Also, I used one of those hand held trigger type attachments you can place onto the top of the can. This gives the can more of a spray gun feel which can help with the application process. You can get them at home depot or pretty much any auto parts store.
Let your first coat dry for approximately 20 minutes or so and go ahead and lightly wet sand the surface. Try not to apply to much pressure as you sand. All you're trying to do here is prep the surface for the next coat. This can be a tedious process but needs to be done if you want the finish to last. You don't want to invest all this time into it just to have it start flaking off in a few days.Apply VHT with wetsanding in between each coat to your desired darkness.
When you have reached your desired tint level you're ready to apply the clearcoat. I used automotive grade clearcoat, use a brand you like, I believe I used krylon. When the surface has been prepped, apply an even coat of clear employing the same technique you used when applying the nightshades. I'll leave it up to you whether or not you want to wetsand in between the clear coats. I didn't, and my lenses still look like they did the day they were completed. When the first coat of clear is dry, apply the next coat thicker and wetter making sure you don' allow the clear to run. If it does, just let it dry and even out the surface by wet sanding. The thicker and wetter you can get the application, the glossier the finish will be. I applied one thin coat and about 4 wet coats before I was satisfied with the finish.
Let the lenses cure for a while, at least for 8 hrs. then use your favorite automotive wax to buff out a nice shine. I used meguiars. When it's all nice and shiny, reinstall and enjoy.
Hope this helps you guys out. I'm in the middle of tinting my stock lenses and awaiting the arrival of more nightshades as my local supplier ran out. I going to do something a little different to these lenses and I think it'll look cool.
Hey Admin, can I get a wrench for this or what? :banana:
gatorrich, you could use them on your headlights but i wouldn't recommend it. There's a project on how paint your headlights.
[Broken External Image]:
I used it as a guide for mine...