Search results

I had a leaker in a 2001. not to tuff of a job. Chutch fan was a pain. Bob

thanks !

Does the clutch fan threads loosen counter clock wise ? Thanks, Bob

Thanks Todd, Can I live without the proper clutch fan tool?

Has anyone had to replace the radiator yet. If so was it an aftermarket and how hard is it to do. Do I need to pull the fan? Thanks, Bob

Hi All, Does this sound like the module. If I flip the switch from 2 to 4 wheel drive. 3 out of 4 times it will go in. Sometimes it won't. No sound from the module at all. Could it be the switch or the module. Is the module and switch dealer items only ?Thanks for any help. Bob

Why not in your pocket. Bob

Thanks Todd. How do you grease the shaft slide yolk. Thanks, Bob

I have a clunk in the rear end of my 2001 Trac when I let off the gas. Will it help to remove the drive shaft and tighten the pinion nut 1/8 to 1/4 turn? Thanks, Bob

Are they soldered in ?

Hi All, Before I take my cruise switch apart, I have a light store that say's they can get any light. Can someone give me the OEM bulb number. Thanks, Bob

I asked Wayne about the fan and fuel pump fuse. He said that it was only for high preformance after market pumps and fans. It's a power draw issue. He told me that it does not apply to a stock ST. So just plug in your programer and go. Bob

So would it be ok to use Mobil One 75-140 wt. synthetic lubricant on an open rear end? Thats what I just did. Now I wonder if I should drain and refill with 75-90. What do you all think. Thanks, Bob

So would it be ok to use Mobil One 75-140 wt. synthetic lubricant on an open rear end? Thats what I just did. Now I wonder if I should drain and refill with 80-90. What do you all think. Thanks, Bob

Got mine from NAPPA it only came with one gasket. I picked up another one at Home Depot. Bob

I did it on my trans. I used a 1/4 in drill bit. I wraped black elect. tape about a 1/2 inch up the bit. and drained the fluid into a 5 gal. bucket. Not one drop on the floor. It took about 20 min to drain complete. Drill it,go have some lunch and it will be drained. Bob

I did it. It works great. Don't go past a 1/4 turn. Bob

It is outstanding. Just installed mine. It's like I put a shift kit in the tranny. Firm/crisp shifts. Throttle responce much improved. My trac is bone stock with 90,000 miles on it. You won't be sorry. Very easy to use as well. Bob

Hi All, I put the Trac in 4wd once a week for about 20 sec. (going straight)just to make sure that the motor won't freeze up. This time when I put it in 4wd. it was just before a stop light. I put it back in 2wd. and stopped for the light. When I took off, I thought that I ran over something...

I put one on my Trac. I just twisted the PCV valve out, Then I spread the metal tube out a bit, pulled off the valve and slipped the new one in place. Closed up the tube a bit and it was done. Not bad at all. Good Luck, Bob