Search results

Anyone have a part number too for an 01? I'd rather pre-buy if possible but there seems to be different pumps.

After looking around more I would be surprised to hear someone say we have an external fuel regulator on the Trac. It appears to me it's an uninterupted line until it "Y"'s off to each fuel rail with the passenger rail having a schrader valve. Am I correct that the only fuel regulator is the...

Trac takes several cranks to start now. After initial cold start it is fine. You can start and stop it all day on first crank. But when you let it sit for a few hours all the pressure is gone. I replaced the pump a few years ago. I don't think it is that this time. I can do the cycle the key...

Looking for a bed cap for my 01 4X4. If anyone has or knows of one in the middle GA area drop me a note please. Thank you, Jason

I don't use the hood pin option. The wire is tapped up so it should never ground but I'll check it again.

Hello all, My OEM Powercode Bronze remote start is really acting up this time. Usually I can fix it but I can't get anywhere now. All fuses are good. Was working before and then it went to a problem I have had before where it will start but then immediately stalll two seconds later...

Josh, Sent you an email. Jason

I need someones stock air box if you have it laying around in your garage. Filter preferred unless really old. :) Shipping to AZ 85356

No, the CHIP is gone. I let it sit over night with the battery disconnected a couple times in the last year so it could relearn everything but still had the same knocking issues. Definitely not the timing chain rattle. I was thinking that the CHIP changed the parameters of the ECU...

I bought one of the SCT performance CHIPS a few years ago but ever since I have had an engine knocking problem between 2-3k when going up hills or towing something. On hots days its worse. temps over 80 degrees. I have ran all types of gas and no improvement. Going through some of the mountain...

I think I just need the box itself that connects to the MAF and goes into the sidewall. The MAF piece should just screw into the box I think but I cant remember. Its been a long time. Switching back to stock because my dealer is blaming my engine knocking on after market parts like filters and...

Looking for a stock airbox. Anyone have one? Shipping to AZ, 85356 Thanks Jason

2001, 4x4, 73K, Tow Package, 4:10 gears, Sun Roof, Leather seats, power windows and locks, power driver seat, fog lights, K&N Filter, Clear Corner lights, and Tinted windows all the way around. Good condition, pads and rotors replaced at 55K, tranny flushed and serviced at 32K and 65K, new...

Posted a bit about this before but I have found new things. The inside edge of my tires were wearing down really bad with less than 10k on the tires plus I have a wobble/rubbing noise at all rpms and really bad vibration at cruising speeds. Just recently took it to my local ford dealer and...

Just spoke with Ford and they said the bearings are good after further inspection and they said all I needed was an alingment. Im a bit skeptical thouhg because I had an alignment done just over a year ago and I rarely ever use it off the pavement. Plus I would say I have not gone futher than...

Dont mean to thread jack but I'm curious as well. My front pass. (01 4x4, 70k miles) has gone south as well. I'd rather do it myself to save the on the labor fees. I have read that some people have there whole hub replaced for about $250 in parts but is it possible to reuse the old hub and...

Hi, thanks for the replys. I dont really have anything to trade unless you want the cone filter on their now. As far as the timing chain rattle, when i had it diagnosed I suggested that but they said they hooked it up to some tool that monitored engine knock and when they drove it around...

Im looking for the factory airbox for a 01 ST. I went to a K&N filter a few years ago and threw my OEM box away. lately i have been trying to solve my detonation problems with the ford mechanics and they claim i need to revert back to the OEM airbox. this is after having replaced a fuel...

Im thinking it has somthing to do with those two themostat sensors in the front under the TB. My porblem thouhg is whose genious design was it to put them under the mani/plenum so that the only way you can remove them is you have to take apart the entire manifold? there is only a 1/4 inch of...

My opinion is Cleaner is not going to work. I have tried that several times. And with only 22k miles Your engine should be in great shape. There is some other culprit.