Search results

Got a 2001 Job 1 4x4... Tranny started to flare real bad not long ago. It would flare between 2-3, and also if it went to downshift into 2nd, it would miss. Everytime.. I bumped up the EPC pressure and it did make it shift a bit quicker...but the flare was still there, and it would...

I do not drive my ST everyday, and have put less than 50 miles on it since this started...... 2001 Job 1 87K miles About 2 weeks ago, I noticed my tranny start to flare betwen 2nd and 3rd. Another thing it started doing at the same time is if I punch the gas at about 45MPH, the tranny...

I just noticed my front tires are wearing heavier on the inside of the tire than on the middle and outside. By inside, I mean towards the center of the vehicle. Obviously an alignment needs to be done, but is there any defects that could be contributing to this? Balljoints? Shocks...

I have been toying with the idea of getting a heavy duty radiator for my Trac. First, I hate plastic sided radiators. I play out in the desert too much, along with many rock hunting trips per summer in places 100s of miles away from civilization; and I have seen them crack too often. My...

OK. So I have developed a suspension squeak. I have sprayed all of the bushings that I know of down with silicone lube, and tend to keep the underside well lubed anyways, but this won't go away! It is coming from the right side, and it squeaks whenever I turn the wheel or when I...

OK. So I have developed a suspension squeak. I have sprayed all of the bushings that I know of down with silicone lube, and tend to keep the underside well lubed anyways, but this won't go away! It is coming from the right side, and it squeaks whenever I turn the wheel or when I...

2001 Job 1 arm rest. Charcoal grey.

2 questions, first, if I get a ProM mass air sensor, do I have to get the computer reflashed? I am going to eventually get an XcalII, but I am going to do the intake and all exhaust work first. If I do have to reflash, I will do the Mass air and XcalII at the same time. If I do not have to...

Anyone know of an aftermarket intake manifold for the 4.0? I have looked around for a while and haven't seen anything. Isn't this the same motor as in the new base model Mustang? I wonder if I should be looking for Mustang parts....

Gotta small vacuum leak.. I can't here it at idle, only between about 2 and 3K. Actually, now that I think about it, it seems less dependant on RPM and more dependant on throttle position. Sounds like it is coming from the passenger side of the motor, but I haven't dug into it too much...

I have got an 01 ST, just purchased used a few months ago, and am getting ready to do some light modding. The cats are bad, so I am going to replace the y-pipe and the main cat with Random technology replacements, and I have some questions for you other modders: Are the Random Technology...

I have got an 03 ST and have acquired an interesting problem. My engine will not rev over 4000 RPM. In any gear. So, as you can assume, it is not very easy to drive right now. I will be in 4th gear, start going up a hill, it wants to downshift, and the motor will not go over 4K RPM, so...