Search results

I wasn’t able to find a replacement turn signal switch for my 2004 Sport Trac. It was out of stock (unavailable or discontinued) everywhere I looked online with no indication it would ever become available and I didn’t want to drive my truck without working turn signals. In desperation I bought...

I want to remove the AC Compressor Clutch Connector so I can test for 12V and determine if a defective clutch is a possible reason for the compressor not turning when the AC switch on the dash is on. I have already determined that there is sufficient coolant in the system. I am not asking for...

The compressor on my 2002 Sport Trac does not ever move when the AC controls on the dashboard are turned on an any postion. After reading several posts, I understand that one troubleshoot method is to 'jump' the low pressure switch for a second or two to see if the compressor turns on for those...

The buzzer no longer sounds when the door is open and the headlights are on or the key is in the ignition. Since it does not sound for either situation, I figure that the problem is with something common to both circuits, such as the buzzer itself, wiring going to the buzzer, or a fuse on the...

My front power window on the drivers side only goes down and inch or so and stops while the 'down button' is being held in. The window goes back up and closes OK when I push the "up button". If I physically push down on the window while activating the "down button" the window still stops after...

My 2002 Sport Trac has 120K miles on it and I just replaced the spark plugs and wires to deal with a 'stumbling upon accelleration' problem. I followed the recommendations on this forum to use Motorcraft SP500 plugs and Taylor 8mm Spiro Pro wires and the engine runs much better now. Great forum...

In reading some of the posts for replacing the #3 spark plug (passenger side nearest the firewall) I have seen the suggestion is to remove the passenger side tire and the inside guard to improve access. I am not sure if this means removing the inner fender (as seen in the attached pic) or just...

I understand that it is generally recommended to replace the pads when replacing rotors. However, I don't know exactly what the probable consequences are of not replacing the pads. I ask because I plan to replace my rotors because are were causing the brakes to pulse and I can not have the...

I suspect that the front left wheel ABS sensor needs to be cleaned on my 2002 4x2 Sport Trac. Long story, but already discussed in another thread. Anyways, my question is this: Is it necessary to remove the rotor to clean the ABS sensor, or can one just remove the wheel and unbolt/remove...

I recently replaced the pads and rotors on my 2002 Sport Trac front wheels. I bought PBR brand rotors and some good quality disc pads. However, after the replacement the front brakes started to slip/jerk when braking at a slow speed. After researching this symptom on this forum, it was suggested...

I have a Ford shop manual and I want to firm up my understanding of what two symbols in the manual mean. The below linked pic shows a page from the manual highlighting the two symbols that I mean These are: 1) A circle with an arrow pointing to one of four postions (0,I,II, or III)...

Well, I got my self into a pickle. The handle on the tailgate does not open the tailgate and I lost the keys to the Ford OEM tonneu cover. I need to get the tailgate open so that I can fix what is wrong with the tailgate lock/handle/power lock actuator, or what ever is causing my problem. I...

I am installing an Alpine 9886 head unit on my 2002 ST. I am unsure about which wire on the Alpine wiring harness connects to the #4 pin (Subwoofer Enable/Clip Detect) on the OEM 8-pin connector inside the dash. Is it the Remote Turn-on wire or the Ignition wire? Thanks in advance for any...

I am installing an Alpine 9886 head unit in my 2002 ST. The below table shows how I think that the 16 pin base connector wires on the ST (inside the dash) should be matched to the Alpine harness (connected to the back of the Alpine head unit), using the wiring harness adapter I got from...

I do not have much automotive repair experience but this forum has got me motivated to troubleshoot my own automotive problems rather than taking my 2002 ST into the shop right away whenever there is a problem. My ST idles and runs fine once it starts, but there has always been a 1-3 second...

Can anyone confirm that there is a fuel pressure regulator on a 2002 ST and describe where it is located? I can't seem to recognize in on the motor anywhere. Also, my OEM (Ford) shop manual does not mention a pressure regulator in the index at the back of the manual or elsewhere inside the...

I want to check whether the fuel line pressure is within spec on my 2002 ST. I already understand how to connect the gauge to the schrader valve on the fuel rail. What I don't know is what readings to expect on the gauge to determine if everything is OK. I want to confirm the following...

I am planning my replacement of the OEM Pioneer 6-disk CD changer with an Alpine 9886 head unit on my 2002 ST. In reading several posts on the excellent forum, I see that a 7805 voltage transister/regulator is suggested to eliminate the "pop" in the factory subwoofer when the head unit is turned...

I am replacing the OEM 6-CD Pioneer head unit with an Alpine CDA-9886 head unit. I planned to purhase the wiring harness that is recommended on the Crutchfield website (see link below). The thing is, I am not completely sure that this is the correct wire harness for my vehicle. Visually, the...

I plan to purchase and install an Alpine CDA-9884 "XM Ready" head unit for my 2003 ST. To get the XM service working with this head unit, I need to purchase and install the Audiovox CNP2000UC Unversal XM Receiver/Tuner, which connects to the head unit via an additional wire harness (CNPALP1...